A low-cost alternative to the U-tie, the Wire Base Tie is designed specifically for laydown forming applications.

The same quality and high performance found in the Western Form Tie is available in the Z-Tie. Allows one-foot offsets to be easily set.

Designed specifically for use with Western Forms' Vertex Brick forming system to break off subsurface of the brick mortar joint and wall face.

Recommended for use in applications where exposed ties, flush to the wall surface, may cause rust staining.

Provide a recess at the form tie location for patching and sealing. Snaps easily over tie and holds tight to form face.

Specifically coined to break horizontally flush to the wall, one tie can be used for three different wall thicknesses.

With all of the features and benefits found in the standard Western Form Tie with a rounded end design.

Designed specifically for laydown forming applications, the U-Tie from Western Forms accommodates any hole pattern and all 2” deep aluminum forming systems. Allow for 48” overdig for form removal.

The tie that set the standard in the aluminum forming industry, the Western Form Tie offers superior performance while still being easy to use. Its rod notch reduces the risk of rebar movement during the pouring process providing a better water seal and includes a location notch for placing horizontal reinforcing steel.